|
|
| (11 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | == USRP ==
| + | A collection of pages on all things RadioFrequency-related: |
| | | | |
| − | * '''Gold'''
| + | {{RF}} |
| | | | |
| − | == SBS-1 ==
| + | [[File:NextG_FAC.png|thumb|W-CDMA Auto-correlation]] |
| − | | + | [[File:Modez_Scope.png|thumb|Modez Scope]] |
| − | === Baseband output ===
| + | [[File:GSM_Waterfall.png|thumb|GSM Waterfall]] |
| − | | + | [[File:USRP_XO_Drift.png|thumb|XO Drift]] |
| − | For a good signal:
| |
| − | | |
| − | * Don't use RP-SMA connector. Instead, take signal from signal 2-pin header on decoder board where the signal is fed through (underneath) from the RF board. The ground must be connected to the shield of the unit's antenna connector! It is not sufficient to ground via the RP-SMA connect, screws, or 2-pin header's ground! Failure to do this will result in a messy signal.
| |
| − | * Don't switch on a separate USRP that is not connected to the unit. E.g. taking the above signal to an LFRX is OK, but switching on another USRP will introduce that weird 'hum' into the signal.
| |
Latest revision as of 18:03, 19 July 2011
A collection of pages on all things RadioFrequency-related:
| v · d · eRadio Frequency related |
|---|
| | Modulations |
Mobile | | | Contemporary | | | Aviation | | | RADAR | |
| | | Software |
| | | Hardware |
| | | Resources |
|
|
